Chrome metal rear light visor
Original reference: VS3621
Note: In the 125 VNB1>2T model, the visor should be painted in color.
Vespa 125 VNB1T>5T
Vespa 150 VBA1T 110486>
Vespa 150 VBB1T>2T
Vespa 150 GS VS5T 0087590>
Vespa 160 GS VSB1T
Related articles
Primary transmission pair TOP Crimaz z24 on 72 bell with reinforced clutch basket and shock absorber for Vespa 50/125 Special-Primavera-ET3
Vespa 50 V5A1T N,L,R
Vespa 50 PK
Vespa 90 V9A1T
Vespa 125 Primavera VMA1>2T
Vespa 125 Primavera ET3 VMB1T
The construction of the teeth is carried out with a module 1.5 gear shaper tool with relative corrections for the pinions added to the original pair.
The width of the tooth has been widened (1 mm inward) to have greater resistance without compromising smoothness. The spring seats have been revised to use springs with square wire. The greater stroke of the shock absorber preserves the gearbox and the cruise. In the center, there is a roller bearing on the most stressed part and a guide bushing on the shaft. This solution allows the bell to be compatible with the original starting gears.
Aluminum quick throttle control pulley "Quick Throttle Disc" for Vespa 50 Special V5B1
Vespa 50 Special V5A2>T
Vespa 50 Special V5B1>4T
Vespa 50 SS V5SS1>T
Vespa 90 V9A1T
Vespa 125 Primavera ET3
Sheath fixing plate to the handlebar for Vespa 125 VNB-150 VBA/VBB-160 GS
Vespa 125 VNB3>6T
Vespa 150 GS VS1T>5T
Vespa 150 VBA1T
Vespa 150 VBB1>2T
Vespa 160 GS VSB1T
Finish: Galvanized
Rollbar tube reinforcement 360 Project Garage 2.1 for Vespa 50 V5A1T L/R-Special V5A2>3T/V5B1>4T-90 V9A1T/125 Primavera ET3- 50/125 PK-S-XL-N-HP-FL-80/125/150/160/180/200 PX-PE-Sprint-TS-GL-Rally-VNB-VBB
Vespa 50 V5A1T L/R-Special V5A2>3T/V5B1>4T-90 V9A1T/125 Primavera ET3 Vespa 50/125 PK-S-XL-N-HP-FL
Vespa 80/125/150/160/180/200 PX-PE-Sprint-TS-GL-Rally-VNB-VBB
Reinforcement bar for Vespa Smallframe Frame 2.1 360 PG CNC
Specific reinforcement bar for the Vespa Smallframe frame, designed to improve structural rigidity while maintaining the correct elasticity of the frame.
The 360 PG CNC bar allows for adjusting the tension or compression of the frame cradle, enabling you to adapt the reinforcement to your needs without compromising the structure's flexibility.
Installation is done via front fastening in the holes intended for the spare wheel support and rear fastening at the height of the bag hook.
Finish and materials: Polished steel and CNC machined aluminum
WARNING: For the rear fastening, 2 holes must be made on the frame.