Reinforced external Evok capacitor for contact point ignition Piaggio Vespa/Ciao/Lambretta
Thanks to the experience gained over the years in the motorcycle sector, EVOK has developed a range of products that stand out for their reliability and quality.
Models with contact point ignition
Related articles
Vespa 125 GT/GTR/TS/Super/PX
Vespa 150 GL/Sprint/S.veloce/Super/PX
Vespa 180 Rally
Vespa 200 Rally/PE
On non-PX models, it is necessary to loosen the luggage rack to remove the engine hood.
Kit completo freno a disco Ottopuntouno per Vespa 50/90/125 Primavera ET3/PK
Vespa 50/90/125 Primavera ET3
Vespa 50 PK S/XL
-Disco da 170 mm
-Pinza e attacco nero
-Lavorazioni a CNC
Plastic fuel tank cap in gray color Oli 2% with gasket for Piaggio Ciao C7/C9 First series
Piaggio Ciao 1st Series
BGM PRO BigBox TOURING V2 (BBT2) Exhaust for Vespa PX80, PX125, PX150, Sprint, GT, GTR
Vespa 125 VNA1>2T
Vespa 125 VNB1>6T
Vespa 125 GT/GTR/TS/Super
Vespa 125 PX
Vespa 150 VBA1T
Vespa 150 VBB1>2T
Vespa 150 Sprint/GL/Super
Vespa 150 PX
The performance level and ground clearance have been significantly increased compared to the previous version.
The new Touring revs significantly higher than the previous BBT.
The exhaust pipe has been expanded from Ø18 mm to Ø20 mm. However, to reduce noise levels, the BBT2 is equipped with an exhaust insert inside the Ø20 mm pipe with Ø18 mm.
This section is sufficient for almost all engines up to 190cc and about 22-25HP (this value varies depending on the engine structure and achievable RPM).
Those driving a very powerful setup with a high continuous RPM can remove the Ø18mm exhaust insert, which is fixed with just one weld point, and thus have the full Ø20mm section.
Increase the main jet by 4-6 points